5 | 2, 4 |
6 | a |
1, 4
b
c
1 Loosen the pan angle adjustment screw.
The pan angle adjustment screw is located on the angle adjuster bracket. Loosen the screw with a Phillips screwdriver before adjusting the camera coverage.
2 Loosen the tilt angle adjustment screw.
The tilt angle adjustment screw is located on the side of the angle adjuster bracket. Loosen the screw with a Phillips screwdriver before adjusting the lens position.
Note
When you adjust the pan angle or tilt angle without the loosening pan or tilt angle adjustment screw, an internal metallic part may be damaged.
3 Turn the lens in the desired direction.
You can adjust the lens position by 
panning, 
tilting, or 
rotating.
4 When you have set the lens in the desired direction, tighten the pan angle adjustment screw and tilt angle adjustment screw to lock in the lens position.
5 Loosen the zoom lever and move it to the right or left to adjust the angle of view.
When you have set the zoom lever to the desired position, tighten it to lock in the angle of view.
6 Loosen the focus lever and move it to
the right or left to adjust the focal length.
When you have set the zoom lever to the desired position, tighten it to lock in the focal length.
7 Repeat steps 1 to 6 until the camera direction and coverage are determined.
Notes
•When adjusting the lens position, be sure that the “MUP” mark on the angle adjuster is toward the ceiling. If the camera is installed with the “MUP” mark toward the floor, the image appears upside down.
•If it is difficult to tighten the zoom lever or focus lever, turn the lens a little with the slip mechanism and try again.
GB 16 Installing the Unit