rVIDEO OUT (Video out) connector

Connect the BNC cable to this connector.

sAC/DC IN (power input) connector

Connect an 24V AC/12V DC cable to this connector.

tUnit casing

The unit casing is made of die-cast aluminum and has conduit holes on the side and at the bottom.

uDome casing

The dome cover is made of polycarbonate. A waterproof rubber gasket is provided on the joint surface to the unit casing.

vSafety cord

This cord prevents the dome casing from falling off the unit casing. Make sure that the cord does not get caught between the dome casing and the unit casing. Rotate the cord and adjust the position of the cord.

wReset switch

To reset the camera to the factory default settings, hold down this switch and supply the power to the camera.

xScrew for drop-prevention rope (Bottom)

 

wg

UP

wh

wj

wk

yCamera installation holes (4 positions)

Make sure to tighten the screws securely when installing the camera.

zPan angle adjustment screw

Loosen this screw before adjusting the lens position, then tighten it to lock in the lens position.

wj Slit cover screws (2 positions)wk Dome case screw hole (3 positions)

This is a ground terminal for the chassis.

Overview

Location and Functions of Parts and Controls 13 GB