Inside

0

w;

qa

 

qs

wa

 

UP

D701

 

D702

 

D702

 

 

ws

qd

 

qf

 

qg

 

qh

wd

qj

 

qk

wf

ql

 

jMON (MONITOR OUT) connector

Connect to a video input connector of a monitor with the supplied monitor cable. You can adjust the camera while looking at the image on the monitor. After adjusting the camera, disconnect the cable.

kLED ON/OFF switch

Set this switch to ON when you want to check by lighting up the POWER indicator and the NETWORK indicator.

Note

Because the LED shine may reflect, normally set it to OFF.

lLED (located in the board, where you cannot find them easily)•NETWORK indicator (orange/ green) (R702/D702)

The indicator flashes in orange when the camera is connected to the 10BASE-T network; it flashes in green when the camera is connected to the 100BASE-TX network.

The indicator goes off when the camera is not connected to the network.

•POWER indicator (green) (D701)

When the power is supplied to the camera, the camera starts checking the system. If the system is normal, this indicator lights up.

mConduit hole plug screw (side conduit hole)

Loosen this screw and remove the plug to use the side conduit hole.

nCable clamp

Secure the BNC cables 24V AC/12V DC cable, I/O cable, audio cable) with this clamp.

oNetwork port (RJ45)

Connect to a hub or computer on the 10BASE-T or 100BASE-TX network using a network cable (UTP, category 5).

pEXT CTRL (External control input/output) connector

Connect an I/O cable to this connector.

qMIC/SP (Microphone/Speaker) connector

Connect an audio cable to this connector.

GB 12 Location and Functions of Parts and Controls