Broadcasts Receiving
Preset Tuning
For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 38.
Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations” below.
Presetting radio stations
1Press TUNER.
The last received station is tuned in.
2Tune in the station that you want to preset using Direct Tuning‚ or Automatic Tuning (page 39).
3Press MEMORY.
“MEMORY” appears in the display for a few seconds. Do Steps 4 to 6 before “MEMORY” goes out.
4Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter “A,” “B” or “C” appears in the display.
5Select a preset number by pressing PRESET TUNING + or PRESET TUNING
If “MEMORY” goes out before you press the preset number, start again from Step 3.
6Press MEMORY again to store the station.
If “MEMORY” goes out before you can store the station, start again from Step 3.
7Repeat Steps 2 to 6 to preset another station.
To change a preset number to another station
Do Steps 1 to 6 to preset the new station to the number.
Note
If the AC power cord is disconnected for about two weeks, all the preset stations will be cleared from the receiver’s memory, and you will have to preset the stations again.
Tuning to preset stations
You can tune the preset stations either of the following two ways.
Scanning the preset stations
1Press TUNER.
The last received station is tuned in.
2Press PRESET TUNING + or PRESET TUNING – repeatedly to select the preset station you want.
Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
Using the preset codes
1Press TUNER.
The last received station is tuned in.
2Press SHIFT to select a memory page (A, B or C), then press the preset number of the station you want using the numeric buttons on the supplied remote.