Parts Identification

4Display section

 

A B

 

 

C

RF

 

AF

 

 

BATT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CH

D

ARF (radio frequency) indications The number of dots indicates the RF input level.

BAF (audio frequency) indication Appears whenever the output audio signal is stronger than the reference level.

CBATT (battery) indication Shows the battery condition.

For details, see “Power Supply” on page 20.

DGP (group)/CH (channel) indication

Shows the reception channel group and channel number. Each time you press the SET button, the channel indication changes as follows.

For details, see “Settings” on page 28.

Reception

 

channel

 

group and

 

number

Press

Reception

the

SET

frequency

button.

 

Accumulated

 

battery use

 

time

 

 

 

5+ (+ selection) / – (– selection/ reset) buttons

Press these buttons to set the reception channel and frequency. The “–” button resets the accumulated battery use time to “00:00”. These buttons can also be used to adjust the monitor level.

6Battery compartment Accommodates two LR6 (size AA) alkaline batteries.

For details on how to insert the batteries, see “Power Supply” on page 20.

7SET button

Press to change display parameters. For details, see “Settings” on page 28.

8POWER switch

Turns the power of the tuner ON or OFF.

9OUTPUT (audio output) connector (3.5-mm diameter stereo mini jack)

Connect one end of the supplied XLR- BMP conversion cable or the stereo mini plug-BMP conversion cable here and the other end to the microphone input on a camcorder, mixer, or amplifier. If the microphone input connector on the device connected to the tuner is a stereo mini jack, connect the straight (BMP) plug (2-pole) to the tuner and the L-shaped (stereo mini) plug (3-pole) to the microphone input connector on the device.

16