Press the + or – button to select the frequency.

Settings

To selct the channel by frequency indication

1 Press the SET button for more than one second.

Keep pressing the SET button until the display seciton parameters start to flash.

2 Press the SET button repeatedly until the frequency indication appears and starts flashing.

3

4 When the desired frequency appears, leave the tuner for about 10 seconds until the selected channel frequency stops flashing and the selection is stored in memory.

Notes

•When you are setting the reception channel, the tuner can be used to receive signals.

•Do not remove the batteries while setting the reception channel. If they are inadvertently removed, re-insert them immediately and redo the procedure “Setting the reception channel” from step 1.

•Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.

•If you turn off the tuner and then immediately turn it on right after setting the reception channel, the unit may not operate normally. Wait a few seconds before turning it on again.

Detecting and selecting the available channels automatically (diversity tuner module (URX-M1) only)

When multiple diversity tuner modules (URX-M1) are installed into the MB-806 to perform simultaneous multiple-channel operation, select the channel group on the tuner module installed into the slot 1 of the MB- 806, then all the tuner mudules installed into the MB-806 can be set to different channels within the selected channel group.

1 Turn off all the microphones and transmitters.

2 Select the channel group on the tuner module installed into the slot 1 of the MB-806.

3 After confirming that the channel group indication has stopped flashing (about 10 seconds after you have selected the channel group), keep pressing the + button on the tuner module installed into the slot 1 of the MB-806.

30