Settings

Resetting theaccumulated battery use time indication

The procedure below is the same for all UWP series transmitters (UTX-B1/H1) and the portable diversity tuner (URX-P1).

The accumulated battery use time is the total time (in hours and minutes) that the batteries have been used. It is recorded whenever the transmitter/ microphone/tuner is on.

Reset the indication to “00:00” whenever you replace the batteries.

1-aFor transmitters (UTX-B1/H1)Turn on the unit while pressing down the SET button.

1-bFor the portable diversity tuner (URX-P1)

Press down the SET button for more than one second.

Keep pressing the SET button until the display section parameters start to flash.

2 Press the SET button repeatedly until the accumulated time indication appears in the display section.

3 Press the – button.

The time indication resets to “00:00.”

While “00:00” is still displayed, you can return to previous value by pressing the + button.

4-aFor transmitters (UTX-B1/H1)Set the POWER switch to OFF to complete the setting, or press the SET button to set other items.

The results are stored in memory. The change becomes effective the next time you turn on the unit by setting the POWER switch to ON.

4-bFor the portable diversity tuner (URX-P1)

Leave the tuner for about 10 seconds until the time indication stops flashing and the setting is stored in memory.

Setting the RF outputlevel

The procedure below is the same for all UWP series transmitters (UTX-B1/H1).

You can select an RF output level of H (10 mW) or L (2 mW) in setting mode. Set the RF output level to L (2 mW) for simultaneous operation of multiple channels, and set it to H (10 mW) for long-distance operation.

1 Turn on the transmitter while pressing down the SET button.

32