SettingsSettingsSetting thetransmission channelThe procedure below is the same for all UWP series transmitters (UTX-B1/H1).

See “Wireless microphone system frequency list” on page 45 for details on the selectable channel groups and channels.

1 Turn on the transmitter while pressing down the SET button.

Keep pressing the SET button until the display section parameters that were displayed when the unit was last turned off start to flash.

2 Press the SET button repeatedly until the channel number (or frequency) indication appears.

3 Press the + or – button to select the channel number (or frequency).

Pressing the + button cycles the indication in the order shown in the tables in “Wireless microphone system frequency list” on page 45.

Pressing the – button cycles the indications in the opposite direction.

Hold down the + or – button to change the channel number (or frequency) faster.

4 When the desired channel number (or frequency) appears, set the POWER switch to OFF to complete the setting, or press the SET button to set other items.

The results are stored in memory. The stored channel number (or frequency) will appear in the display section the next time you turn on the transmitter by setting the POWER switch to ON.

Notes

When you are setting the transmission channel, the transmitter cannot be used to transmit signals.

Do not remove the batteries while setting the transmission channel. If they are inadvertently removed, re- insert them immediately and redo the procedure “Setting the transmission channel” from step 1.

Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.

If you turn off the transmitter and then immediately turn it on right after setting the transmission channel, the unit may not operate normally. Wait a few seconds before turning it on again.

28