OperationOperation
The procedure below is the same for all UWP series components
1 Make all necessary connections on the tuner.
For examples of UWP series component connections, see “System Configurations” on page 35.
2 Set the transmission channel on the transmitter, and then turn off the unit.
For details on setting the transmission channel, see “Setting the transmission channel” on page 28.
3 Turn on the tuner.
The parameters that were in the display section when the tuner was last turned off appear again.
Note
Before turning on the tuner, turn down the volume of the equipment connected to the tuner. Otherwise, noise will be produced when the tuner is turned on.
4 Set the reception channel on the tuner.
For details on setting the reception channel, see “Setting the reception channel” on page 29.
5 Turn on the transmitter.
If noise is heard
Depending on the environment where the UWP series components are installed, external noise or radio waves may disrupt transmission on certain channels.
When selecting a channel under these circumstances, turn off the transmitter. Then, on the tuner, select a channel for which the RF indications do not appear in the display section or for which the RF indicator does not light up (i.e., a channel free from noise or radio wave interference). Set the same channel on the transmitter.
Note
To prevent interference or noise, please take the following precautions.
•Do not use two or more transmitters with the same wireless channels.
•When operating two or more UWP series simultaneously, set each series to a different channel within the same channel group.
•Keep the reception antenna and the transmitter separated more than 3 meters (9 feet 11 inches).
•When operating two or more UWP series simultaneously with the same channel group, make sure that they are at least 100 meters (330 feet) apart, but within clear sight of each other. (The actual distance may differ depending on the circumstances.)
34