7 Adjust the picture size and position.

Screen

Projected picture

If “Side Shot” or “V Keystone” are adjusted manually (value adjustment), the built-in test pattern is projected on the screen. If you want to make adjustments using the current input signal, set “Test Pattern” in the INSTALL SETTING menu to “Off.” (1 page 32)

When projecting using “Side Shot” adjustment only

When projecting using “Side Shot” adjustment only, you can adjust to correct horizontal trapezoidal distortion using the “Side Shot” function to the maximum.

1Set “V Keystone” in the INSTALL SETTING menu to “Manual", press ENTER and M, m or RESET to set the level to “0”, then reset the position of the adjuster (1 page 16).

Note

If “V Keystone” is set to “Auto,” the correction capacity of “Side Shot” is reduced.

2Position the projector so that the picture overlaps on the screen as shown below.

Adjust so that the bottom side of the picture is parallel to the bottom side of the screen.

Check that the vertical sides of the picture are parallel to the vertical sides of the screen.

If the picture does not overlap on the screen as shown above, confirm and adjust the installation position of the projector and screen referring to “Installing the Projector and a Screen” (1 page 8).

3Move the projector vertically so that the bottom side of the picture fits the bottom inside of the screen frame.

Adjust so that the bottom side of the picture fits the bottom inside of the screen frame.

When adjusting the picture height, do not use the adjuster (1 page 16), but move the projector or the screen vertically to adjust so that the bottom side of the picture fits the bottom inside of the screen frame.

4Move the projector horizontally to the left or right so that one side of the picture fits the inside end of the screen frame.

Adjust so that one side of the picture fits the inside end of the screen frame.

If you position the projector on the left side of the screen, adjust so that the left side of the picture fits the left inside end of the screen frame. With the projector positioned on the right side, adjust so that the right side of the picture fits the right inside end of the screen frame.

Note

When adjusting so that one side of the picture fits the inside end of the screen frame, make sure not to separate the bottom side of the picture from the bottom inside of the screen frame.

and Connections Preparations

Step 3: Adjusting the Picture Size and Position

17 GB