Sony VPL-HS3 manual Others

Others

This section describes how to solve the problems, how to replace a lamp and air filter, etc.

Troubleshooting

Power

Picture

No picture.	c Check that the proper
	connections have been made.
	(1 page 9)
	c Select the input source correctly
	using the INPUT button.
	(1 page 23)
	c Set the computer signal to output
	from an external monitor.
	c Set the computer signal to output
	only to an external monitor.
	c Select “Computer”,
	“Component” or “Video GBR”
	for “Input-A Signal Sel” in the
	SET SETTING	menu
	according to the input signal.
	(1 page 31)
The picture from the PJ	c Select “Computer”,
MULTI connector is	“Component” or “Video GBR”
colored strange.	for “Input-A Signal Sel” in the
	SET SETTING	menu
	according to the input signal.
	(1 page 31)
Color balance is	c Adjust the picture in the “Adjust
incorrect.	Picture ...” of the PICTURE
	SETTING	menu
	(1 page 29).
	c Set “Color System” in the SET
	SETTING	menu to match
	the color system being input.
	(1 page 31)
The picture is too dark.	c Adjust the contrast or brightness

The power is not turned on.

cWait for about one minute before turning on the power. (1 page 24)

cClose the lamp cover securely. (1 page 36)

cClose the air filter cover securely. (1 page 38)

	in the “Adjust Picture ...” of the
	PICTURE SETTING		menu
	properly. (1 page 29)
The picture is not clear. c Adjust the focus with the
	FOCUS ring. (1 page 23)
	c Condensation has occurred on
	the lens. Leave the projector for
	about two hours with the power
	on.
The picture flickers.	c Adjust “Dot Phase” for “Adjust
	Signal...” in the INPUT
	SETTING	menu properly.
	(1 page 30)

GB 34 Troubleshooting