For Machines Mfg. Since 3/11 | P R E P A R A T I O N | EVS Toolroom Lathe w/DRO |
Cleaning & Protecting
The unpainted surfaces are coated at the factory with a
Be patient and do a careful job when cleaning and removing the rust preventative. The time you spend doing this will reward you with
Although there are many ways to successfully remove the rust preventative, we have cleaned thousands of machines and found the following process to be the best balance between efficiency and minimized exposure to toxic fumes or chemicals.
Before cleaning, gather the following:
ss $ISPOSABLE rags
ss#LEANERDEGREASER (certain
degreasers work extremely well and they have
ss 3AFETY GLASSES DISPOSABLESGLOVES
Note: Automotive degreasers, mineral spirits, or 7$ssCANBE USEDNTO REMOVEURUST PREVENTATIVE
Before using these products, though, test them on an inconspicuous area of a painted surface to make sure they will not damage it.
Gasoline and petroleum products have low flash points and can explode or cause fire if used for cleaning. Avoid using these products to remove rust preventative.
Many cleaning solvents are toxic if inhaled. Minimize your risk by only using these products in a well ventilated area.
Avoid
Basic steps for removing rust preventative:
1.Put on safety glasses and disposable gloves.
2.#OAT ALL SURFACES THAT HAVEARUST PREVENTATIVE with a liberal amount of your cleaner or degreaser and let them soak for a few minutes.
3.Wipe off the surfaces. If your cleaner or degreaser is effective, the rust preventative will wipe off easily.
Note: To clean off thick coats of rust preventative on flat surfaces, such as beds or tables, use
AA0,!34)#!PAINT)SCRAPERATO SCRAPESOFFRTHEP
majority of the coating before wiping it off
WITH YOUR RAG $O NOT USE A METAL SCRAPER OR it may scratch the surface.)
4.Repeat Steps
Remove the end gear cover and end gears, and use a stiff brush with mineral spirits to clean the rust preventative from the gears and shafts. DO NOT get any cleaner or rust preventative on the