Southbend SB1059F owner manual Removing Tooling, Offsetting Tailstock, To offset the tailstock

EVS Toolroom Lathe w/DRO O P E R A T I O N For Machines Mfg. Since 3/11

Removing Tooling

1.Use a shop rag to hold the tool.

2.Rotate the tailstock handwheel counterclockwise until the tool is forced out of the quill.

—If the tool does not come loose by retracting the quill, extend the quill and use a drift key in the slot shown in Figure 42 to remove the tool.

Drift Key Slot

Figure 42. Drift key slot in the side of the quill.

To offset the tailstock:

1.Loosen the hex bolts underneath both ends of the tailstock to release the clamping pressure between the top and bottom castings (see Figure 43).

Adjustment

Set Screw

(1 of 2)

Offset

IndicatorHex Bolt

(1 of 2)

Figure 43. Tailstock offset controls.

2.Rotate the adjustment set screws in opposite directions for the desired offset (see the illustration in Figure 44).

Offsetting Tailstock

The tailstock can be offset from the spindle centerline for turning tapers. Move the tailstock top casting toward the front of the lathe to machine a taper at the tailstock end. Conversely, position the tailstock top casting toward the back of the lathe to machine a taper at the spindle end.

Note: The marks on the offset indicator are
arbitrary. For a precise offset, use a dial
indicator to check quill movement while
adjusting the screws.
Tools Needed	Qty
Hex Wrench 6mm	1
Wrench 17mm	1

Turn	Turn	Turn	Turn
CCW	CW	CW	CCW

Figure 44. Set screw adjustment in relation to

tailstock movement.

3.Retighten the clamping hex bolts underneath the tailstock to secure the offset.

-44-