SOYO 6KB82440 manual PS/2 Mouse Connector, IR IR Connector, Keylock & Power LED Connector

Hardware Setup 9

PS/2 Mouse Connector

A six-pin female PS/2 mouse connector is located at the rear of the board. Plug the mouse jack into this connector.

IR – IR Connector

A ten-pin wafer connector is for connecting to the IR device. Use the device that has the ASKIR or HPSIR specification and choose ASKIR/HPSIR from the BIOS setup.

IR Connector

Pin Assignment

VCC 1

FIRRX 2

IRRX 3

GND 4

IRTX 5

6Empty

7CIRRX

8VSB

9Empty

10Empty

There are two ways to use this IR function. One is to connect a 5-pin IR device and treat it like an ordinary IR port. The other way is to connect a 10-pin IR device and use the advanced ÒIR Wake UpÓ PC function. Ask your IR provider for the new ÒIR Wake UpÓ function.

Keylock & Power LED Connector

This connector is for a lock that may be installed on the system case for enabling or disabling the keyboard. This connector also attaches to the caseÕs Power LED. (Pin 1, 3 for power LED, pin 4, 5 for keylock.)

SPK – Speaker Connector

Attach the system speaker to connector SPK.

RST – Hardware Reset Control

Attach the Reset switch to RST. Closing the Reset switch restarts the system.