6.4.1.1 Install

This item allows you to install each channel on 1 Configuration Table1. Every channel is “installed” by default; you may uninstall any one of them manually. Once a channel is un-installed, all related functions are disabled (√ = camera installed; • = camera not installed).

6.4.1.2 Covert

This item allows you to make each camera’s input invisible (covert) on both main and call monitor, while DVR-16/IP keeps recording the camera’s video. The default setting is every camera visible (√ = covert; • = not covert).

6.4.1.3 PTZ

Set this item to enable, users can set the following external device OSD settings through the DVR-16/IP front panel. Press the number button corresponding to the wanted camera to make it full screen, and then press the SET button to go to the “External Devices” Menu.

RS-485 Baud Rate

External Devices

1 RS-485 Baud Rate

2 DSCP Speed Dome

3 CHIPER CRT.V9KRP

4 PELCO Speed Dome

5 Exit

Baud rate is a number related to the speed of data transmission in your security system. The higher the baud rate, the more bits per second that are transferred. Before the data are transferred between two devices, you must ensure that both devices are configured to the same transmission rate.

DSCP Speed Dome

This sub-menu is offered to adjust the dome settings. After you are in the sub-menu, you can pan/ tilt the speed dome freely by pressing SET and the direction buttons simultaneously.

RS-485 ID Setup

 

DSCP Speed Dome

 

1

RS-485 ID Setup

XXX

2 Zoom

 

3

Brightness

 

4

Set Preset Point

XXX

5 Enter Speed Dome Menu

 

6

Exit

 

 

 

 

If you want to control the DSCP Speed Dome through the front panel, you should firstly check and modify the RS-485 ID here.

Zoom

Press the Enter button to enter the Zoom mode. You can simply push the right direction button to zoom in (tele) and the left direction button to zoom out (wide). Press the ESC button to exit the Zoom mode.

Brightness

Use the right and left direction buttons to adjust the brightness of the selected dome camera. Press the ESC button to exit.

Set Preset Point

This item allows you to set the preset points. Pan/ Tilt the dome camera to the wanted position and give the preset point a number, and then press the Enter button.

Enter Speed Dome Menu

Press Enter on this item to go to the OSD menu of installed Speed Dome.

16

Page 17
Image 17
Speco Technologies DVR-16/IP user manual Install, Covert, 1.3 PTZ, RS-485 Baud Rate, Dscp Speed Dome