KIRK Repeater Installation 51
KIRK Wireless Server 600v3 Installation and Configuration Guide
2Mount the bracket onto the wall using the anchors and screws accompanying the repeater.
Note: Do not fasten the screws completely to allow for adjustments of the cable length when
connecting the cable to the repeater.
Figure 15 Bracket Template
Figure 16 Bracket Mounted onto the Wall
3Connect the cable into the RJ11 connector on the repeater.
4Adjust the length of the cable and then fasten the mounting bracket.
5Insert the plastic hooks on the rear of the KIRK Repeater into the mounted bracket and push
the repeater down until it clicks into place. See Figure 16 on page 51 and Figure 17 on page
51.
Figure 17 Plastic Hooks on Rear of KIRK Repeater
5
Note: If you need to remove the KIRK Repeater, please seperate it from the mounting bracket
with a gentle push of a screwdriver inserted between the mounting bracket and the repeater.
Drill holes for
screws or
anchors at these
points
Template for Drilling Mounting Screws
2 inches
(5 cm)
Connector
Cutout
Upper
Screw
Lower
Screw
Plastic Hooks