98 Configuring KIRK Wireless Server 600v3
14117800, Ed.2
7.6.1.7 Configuring DECT System (Primary)1Under the Configuration menu, click DECT, and then click System.
Figure 51 Adm. Page: Configuration/DECT/System page
2In the Name field, the name MUST ALWAYS be DECT.
If changing the name, the system cannot operate.
3In the PDW (password) field, type the password, and then type it again in the field below.
4From the Subscriptions list, select either Allow Anonymous, With User AC only, or
Disabled.
Note: It is recommended to select With User AC only. When subscribing a new handset to
the system it is possible to use an authentication code (AC). If you want to use the
authentication code, you must select With User AC only. For more information about
subscription of handsets and authentication codes, refer to “Subscribing Handsets” on page
162.
5From the Tones list, select a ring tone.
6If SIP Protocol: Select the Enbloc Dialing check box.
The Enbloc Dialing check box has to be enabled in a SIP configuration in order for the
handset to collect all digits, before passing them on to a call handler for routing.
Note: The Enbloc Dialing check box is not to be selected, when using H323 Protocol or
SKINNY Protocol.