Star Micronics SP2000 manual Comdex dual auto-cutter, Paper near end sensor

n4	Comdex dual auto-cutter
“0” to “7”	Invalid
“8” to “F”	Valid

*1: Comdex Dual Auto Cut Mechanism (STAR mode only)

This mechanism automatically cuts when there is a consecu- tive paper feed exceedin 7/6 inch. Hosts that cannot send an escape sequence such as <ESC> “d” and 0, can cut the paper if a line feed code <LF> of 1/6 inch is sent 7 times consecutively.

N = 2 (ESC/POS mode)

n1: Always “0”

n2: Always “0”

n3: Always “0”

Parameter	Setting			“0” to “F”
n4	Paper near end			See below
	sensor
n4			Paper near end sensor
“0” or “4” or “8” or “C”		Invalid
“1” or “9” or “D”			Invalid
“2” or “A” or “E”			Reflects status of sensor to STATUS
			and when near end, does not go offline
			and does not stop printing.
“3” or “B” or “F”			Reflects status of sensor to STATUS
			and when near end, goes offline and
			stops printing.

4)N = 3 (Star mode) n3: Always “0”

Parameter	Setting	“0” to “F”
n1	Character table
n2	Character table	See below
n4	CR code

39