58
• Magnetic stripe write retry count setting
This command sets the number of times the device will retry to write to the magnetic stripe.
Settings using this command function as default settings in the magnetic stripe write → idle
command 31h and magnetic stripe write → idle (status with no card) command 32h.
STX, 91h, ‘W’/‘w’, magnetic write retry count setting, ETX, BCC
Magnetic write retry count setting parameters
‘0’: No retry
‘1’: Sets the magnetic write retry count to 1 times.
‘2’: Sets the magnetic write retry count to 2 times.
‘3’: Sets the magnetic write retry count to 3 times.
‘4’: Sets the magnetic write retry count to 4 times.
‘5’: Sets the magnetic write retry count to 5 times.
‘6’: Sets the magnetic write retry count to 6 times.
‘7’: Sets the magnetic write retry count to 7 times.
The ex-factory magnetic write retry count setting is 2 times.
• Cleaning operation repeat count setting
This command sets the number of times to repeat the cleaning of the thermal head. Settings
using this command function as default settings in the cleaning operation by the command
52h, and the cleaning operation by pressing the cleaning switch.
STX, 91h, ‘U’/‘u’, cleaning count setting, ETX, BCC
Cleaning count setting parameters
‘1’: Sets cleaning count to 1 times.
‘2’: Sets cleaning count to 2 times.
‘3’: Sets cleaning count to 3 times.
‘4’: Sets cleaning count to 4 times.
‘5’: Sets cleaning count to 5 times.
‘6’: Sets cleaning count to 6 times.
‘7’: Sets cleaning count to 7 times.
The ex-factory cleaning count setting is 3 times.