30
Command Transfer Formats
ST
X
42h
Data
arrangement
specification
‘,’
Data
arrangement X
coordinate
‘,’
Data
arrangement Y
coordinate
‘,’
Expansion
image
specification
number
ETX BCC
Response Transfer Formats
STX 42h Status ETX BCC
Parameter Explanation
• Data arrangement specification parameter
To specify whether to use the internal vertically or horizontally, select ‘0’ to ‘3.’
‘0’: Vertical card + overwrite
‘1’: Horizontal card + over write
‘2’: Vertical card + added writing (recommended)
‘3’: Horizontal card + adde d writing (recommended)
These four parameters specify how to write.
• ‘,' (Commas)
Required to separate parameters.
• Data arrangement X coordinate parameter
Specifies the X coordinate on the upper left edge of the image to expand.
When the card arrangement specification is ‘0,’ ‘2’: ‘0’ to “319”
When the card arrangement specification is ‘1,’ ‘3’: ‘0’ to “479”
• Data arrangement Y coordinate parameter
Specifies the Y coordinate on the upper left edge of the image to expand.
When the card arrangement specification is ‘0,’ ‘2’: ‘0’ to “479”
When the card arrangement specification is ‘1,’ ‘3’: ‘0’ to “319”
• Expanded image specification number parameter
Data count can be set to a maximum of 2000 types, so specify with characters from ‘0’ to
“1999.” However, a reject response is issued if an image data that corresponds to the
reader/writer flash ROM1 cannot be found.