Star Micronics TSP600 user manual OFF No. 1 2 3 4 5 6 7 DIP-SW3

The following is the procedure for changing the settings on DIP switch No. 3.

1.Turn off the printer and all components connected to it.

2.Remove the 2 screws.

3.Remove the serial interface board unit.

4.Change the setting of the DIP switches.

5.Replace the serial interface board unit. Then secure it with the screws.

6.Turn on the printer and all components connected to it.

APPENDIX

ON

OFF No. 1 2 3 4 5 6 7 8

DIP-SW3

The factory settings of DIP switch are all on, except for switches 7 and 8.

DIP-SW 3

Switch		Function		ON		OFF
3-1		Baud Rate			See table below
3-2
3-3		Data Length		8 bits		7 bits
3-4		Parity Check		Disabled		Enabled
3-5		Parity		Odd		Even
3-6		Handshake		DTR/DSR		XON/XOFF
3-7	Pin #6 (DSR) reset signal			Valid		Invalid
3-8	Pin #25 (INIT) reset signal			Valid		Invalid
	Baud Rate		Switch 3-1			Switch 3-2
	4800BPS		OFF			ON
	9600BPS		ON			ON
	19200BPS		ON			OFF

– 103 –