Star Micronics TSP600 user manual Parallel Interface Type, ESC/POS mode

B-1. Parallel Interface Type

ON

OFF

No. 1 2 3 4 5 6 7 8

DIP-SW1

ON

OFF

No. 1 2 3 4

DIP-SW2

	DIP-SW 1
Switch 1-1		Command emulation
ON		Star Mode
OFF		ESC/POS Mode

All factory settings for dipswitch 1 on the auto cutter model are set at [ON]. Switch 1-3 on the tear bar model is set at [OFF], and the others are set at [ON].

The functions of switches 1-2 through 1-8 will change according to the command emulation that has been set using switch 1-1.

(1) Star mode

	Switch	Function	ON	OFF
	1-1	Command emulation	Always ON
APPENDIX
	1-2	Should not be changed (Should be set to on)
	1-3	Auto cutter	Valid	Invalid
	1-4	Sensor adjustment	Invalid	Valid
	1-5	Pin #31 (INIT) reset signal	Valid	Invalid
	1-6	Handshaking conditions	Offline or receive	Receive buffer full
		(conditions for BUSY)	buffer full
	1-7	Automatic status back function	Invalid	Valid
	1-8	Should not be changed (Should be set to on)

(2) ESC/POS mode

Switch	Function	ON	OFF
1-1	Command emulation	Always OFF
1-2	Graphic adjustment	203 DPI	180 DPI
1-3	Auto cutter	Valid	Invalid
1-4	Sensor adjustment	Invalid	Valid
1-5	Pin #31 (INIT) reset signal	Valid	Invalid
1-6	Handshaking conditions	Offline or receive	Receive buffer full
	(conditions for BUSY)	buffer full
1-7	Automatic status back function	Invalid	Valid
1-8	Should not be changed (Should be set to on)

– 99 –