Star Micronics XR-1520, XR-1020 manual Paper menu, Forms menu, Penabled

&

c

i

L.

.

L

c.

L.

Ic.

i.

L.

Paper menu

This menu allows you to set up various handling options of paper.

•Paper-out detector

When this switch is [DISABLED] the printer ignores the paper-out detector and prints down to (and beyond) the bottom edge. Otherwise leave it

PENABLED].

•Multi-part mode

Youcanuseupto3-plypaperwithnonnalmode, PDISABLED]. Ifyouwant to print on 4-ply or S-ply paper, set the Multi-part mode to [ENABLED].

9 Automatic Sheet Feeder

In order to use the optional Automatic Sheet Feeder, set this switch to the related position. [SINGLE] for single-bin ASF, [DUAL-l]for the front bin of Dual-bin ASF, and [DUAL-21for the rear bin of the Dual-bin ASF.

If you do not use the optional Automatic Sheet Feeder, leave this [*OFF].

. Auto loading amount for each paper type

Sets the first line position on the each paper type.

Forms menu

The Forms menu allows you to set various options associated with paper handling.

•Tear-Off function

You can select the Tear Off function with this switch [ENABLED]. When using fanfold paper, the Tear Off function allows you to tear off one sheet of paper without fully advancing the following sheet.

•Skip-over-perforation

You can select the Skip-over-perforation with this switch [ENABLED]. It is recommended to skip close to the perforation of fanfold forms to get good print quality. Ifyoucannotsetthisfunctionwithyoursoftware,setthisswitch[ENABLED].

The printer automatically skips the perforations.

•Auto Line Feed with CR

If you set this switch [*DISABLED], a separate line-feed code is required from your computer to obtain a line feed.

If you set this switch [ENABLED], the printer performs both a carriage return and line feed each time it receives a carriage-return code.

Most computer systems send a line feed code, or both a carriage return and line feed, at the end of each line, so this switch should be left [*DISABLED].

L 61