![](/images/new-backgrounds/1057825/5782557x1.webp)
S U F S E R V I C E H A N D B O O K
T R O U B L E S H O O T I N G
120 VAC TO IGNITOR
STEP 10
120 VAC TO IGNITOR
STEP 10: CHECK FOR 120 VAC TO IGNITOR FROM PIN 1 AND 2 ON CONTROL BOARD TERMINAL CN5.
Condition:
•Disconnect CN5 plug from control board.
•On/Off switch is on.
•Call for heat is activated.
•Perform test during ignitor warm up period.
IF... |
| THEN | |
|
|
| |
|
|
| |
120 | VAC is not present | replace the control board if Steps 7 through 9B have | |
been performed and results were successful. | |||
|
| ||
|
|
| |
120 | VAC is present | continue to step 11. | |
|
|
|
Technical Training Department | 28 | State Water Heaters |
Ashland City, Tennessee © 2004 |