Summit 3522a manual Error Code Definitions

4 — OPERATOR SERVICE

ERROR CODE DEFINITIONS

The DISPLAY PANEL located on the ground control panel indicates the present operating status of the boom lift. If an error condition is detected by the control processor during start-up or operation, the appropriate error code will be displayed on this panel.

Refer to Table 4-2 for a comprehensive list of Error Code Definitions and solutions.

Table 4-2. Error Code Definitions

	ERROR MESSAGE	DEFINITION OF ERROR
001	MACHINE IS IN DOWN ONLY	Machine was either never leveled, outriggers not
	MODE	lowered, or machine went out of level with use.
002	LOSS OF PLATFORM	Ground control lost communication with platform
	COMMUNICATION	control.
005	PLATFORM CONTROL HAS	Platform control detected a stuck or pressed key
	STUCK KEY	on power up.
008	GROUND CONTROL HAS	Ground control detected a stuck or pressed key
	STUCK KEY	on power up.
009	BOOM UP WITHOUT	Ground control detected the boom is up and all
	OUTRIGGERS ON GROUND	outriggers are not on the ground
010	LEVEL SENSOR HAS	The ground control detected an erratic output
	ERRATIC OUTPUT	from the level sensor.
015	MACHINE IS NOT LEVEL	Machine has gone out of level with use.
016	LIFT BOOM	A boom rotate, extend, or retract function
		requested with boom down.
017	STOW BOOM	An outrigger function requested with boom up.

021OPEN CIRCUIT PRIMARY UP A load of less than 70mA detected in primary up circuit on power-up.

022	SHORTED CIRCUIT	Excessive load detected in primary up circuit on
	PRIMARY UP	power-up.
023	OPEN CIRCUIT PRIMARY	A load of less than 70mA was detected when
	DOWN	primary down circuit was energized
024	SHORTED CIRCUIT	Excessive load detected when primary down
	PRIMARY DOWN	circuit was energized.
025	OPEN CIRCUIT SECONDARY	A load of less than 70mA detected in secondary
	UP	up circuit on power-up.
026	SHORTED CIRCUIT	Excessive load detected in secondary up circuit
	SECONDARY UP	on power-up.
027	OPEN CIRCUIT SECONDARY	A load of less than 70mA detected when
	DOWN	secondary down circuit was energized
028	SHORTED CIRCUIT	Excessive load detected when secondary down
	SECONDARY DOWN	circuit was energized.
029	OPEN CIRCUIT JIB UP	A load of less than 70mA detected in jib up circuit
		on power-up.
030	SHORTED CIRCUIT JIB UP	Excessive load detected in jib up circuit on
		power-up.

COMMENTS

Retract boom to travel position and extend outriggers using AUTO LEVEL button.

Check for unplugged or damaged platform control cable.

Turn key switch off and on again without pressing any buttons.

Turn key switch off and on again without pressing any buttons.

Retract boom to travel position and extend outriggers using AUTO LEVEL button.

Retract and extend outriggers using AUTO LEVEL button.

Retract and extend outriggers using AUTO LEVEL.

Raise boom from travel position.

Retract and lower boom to travel position.

Check for faulty boom up solenoid coil and wiring.

Check for faulty boom up solenoid coil and wiring.

Check for faulty boom down solenoid coil and wiring.

Check for faulty boom down solenoid coil and wiring.

Check for faulty boom up solenoid coil and wiring.

Check for faulty boom up solenoid coil and wiring.

Check for faulty boom down solenoid coil and wiring.

Check for faulty boom down solenoid coil and wiring.

Check for faulty jib up solenoid coil and wiring.

Check for faulty jib up solenoid coil and wiring.

29