Sun Microsystems 820-4733-10 service manual Removing CMCs, Removing a CMC

For example, to deactivate CMC0 (10h):

#clia deactivate 10 0

Pigeon Point Shelf Manager Command Line Interpreter Command issued via IPMB, status = 0 (0x0) Command executed successfully

#

Instead of deactivating a CMC, you can use the clia switchover command. The clia switchover command transfers control of the Sun Datacenter Switch 3456 from one CMC to the other. For example:

#clia switchover

Note – You can use the clia switchover command on either the active or the inactive CMC with the same results. The inactive CMC becomes active, the active CMC becomes inactive.

5.3Removing CMCs

▼Removing a CMC

1.If the active CMC is to be removed, use the clia switchover command to transfer administration duties to the other CMC.

Otherwise, continue to Step 2.

2.Remove any cables connected to the CMC front panel.

3.Squeeze the latches on the release levers and wait for the blue Ready-to-Remove LED to light.

4.Swing the release levers outward.

See FIGURE 5-1.

Chapter 5 Chassis Management Controller Service Procedures 5-3