FIGURE 3-6 Attaching the Power Cord
The Connected LED lights to indicate the power supply is connected to facility power.
7.Use the enablepsu command to bring the power supply to a fully powered state.
8.Verify the power supply’s operation with the showpresent and psustatus commands.
3.5Powering On Power Supplies
When facility power is applied to a power supply, it enters a standby state. You can apply facility power by:
■Plugging the power cord from the power supply into a ‘live’ receptacle
■Energizing the respective circuit breaker for the power supply
Chapter 3 Power Supply Service Procedures |
