Sunbeam EM8910 manual Milk frothing continued

Milk frothing (continued)

•Swing the steam nozzle out to the side of the machine and hold the jug under the steam nozzle so that the nozzle opening is completely immersed in the milk. Turn the ‘steam/hot water’ switch up to activate the steam and commence frothing the milk. See figure 27.

LCD: Indicates <<STEAM>>.

Tip: For instructions on how to froth milk refer to the section ‘Easy steps for frothing milk’.

Note: The nozzle must not touch the bottom of the jug to ensure that the steam release is not obstructed.

•To stop the frothing process, turn the ‘steam/hot water’ switch down into the off • position and then remove the jug. See figure 28.

Important: There is risk of scalding by splashing hot milk. Switch the steam off before you remove the jug with the frothed milk.

•Exit the steam mode by pressing the steam pre-selection button, the indicator light will turn off and the appliance is now ready again for making coffee.

See figure 26.

Tip: After steaming and the steam mode has been deselected on the control panel, turn the ‘steam/hot water’ switch up and allow hot water to run out for a couple of seconds.

LCD: Indicates <<HOT WATER>>.

This will help the temperature of the espresso machine return to coffee making temperature and also prevent milk remains from drying inside the steam nozzle and therefore blocking the nozzle. Be sure to place a cup of some kind under the steam nozzle when doing this.

21