Sunbeam EM8910 manual Running the cleaning program

Running the cleaning program

The cleaning program allows complete removal of coffee oils even in areas which are not normally accessible. Start the cleaning program at the latest when you are instructed by the display indication

<<CLEANING REQUIRED>>.

The cleaning process takes about 8 minutes and should not be interrupted. If it is interrupted the cleaning process has to be started again.

Important: Prior to starting the cleaning program, clean the coffee brewing unit and empty the coffee waste container. Refill the water reservoir with approximately 1 litre of fresh water.

Important: Use the Sunbeam ‘Cleaning’ tablets only. If using other cleaning agents, Sunbeam will not be liable for any damage. Sunbeam cleaning tablets are available from selected appliance retailers or from Sunbeam on 1800 025 059.

•Press the “MENU” button. The menu setting <<LANGUAGE>> appears.

• Press the scrolling buttons ▼ or ▼ until the menu setting <<CLEAN >> appears.

•Confirm the menu setting by pressing the “OK” button. The display shows <<START CLEANING>>.

•Confirm with the “OK” button. The display shows <<CLEANING INSTRUCTIONS>>.

Important: To prepare for cleaning, follow the instructions on the display then press “OK” to confirm that you have done so.

•<<REFILL WATER RESERVOIR>>

– press “OK”

Remove the water reservoir, fill it with water and replace. Then press the “OK” button.

• <<BEAN HOPPER TO PRE-GROUND>>

Note: This message only appears when the bean hopper is in whole bean mode.

Figure 58

Figure 59

Figure60

Turn the bean hopper to the pre-ground coffee position, see figure 58.

36