Sunbeam EM8910 manual Trouble Shooting Guide continued, Problem, Possible Cause, What To Do

Trouble Shooting Guide continued

PROBLEM	POSSIBLE CAUSE	WHAT TO DO
No espresso/coffee,	Foreign matter is caught in the	Turn the machine off and remove
only water is running	grinding mechanism stopping	the hopper. Clean away any coffee
out	the beans from moving through	beans in and around the grinding
	the grinder.	mechanism. Remove the grinding
		ring and with the cleaning brush or
		tweezers remove any foreign
		matter. See page 26, Removing
		foreign matter from the grinding
		mechanism.
	Coffee bean hopper is not	The grinder is working however
	fitted correctly.	there is no sound of coffee beans
		grinding. Remove the hopper and
		empty the coffee beans into a
		container. Replace the hopper onto
		the grinding mechanism, check
		that the lock on the base of the
		hopper opens once it is in the
		coffee bean position, if it remains
		closed while turning the hopper,
		remove the hopper and try
		engaging it again. Therefore push
		down on the hopper with pressure,
		whilst turning.
	Brewing unit is not	Should the grinder be working
	in the correct position.	normally, remove the coffee waste
		container after the espresso making
		process and check to see if there
		is any freshly ground coffee. In this
		case turn the machine off, remove
		and clean the brewing unit.
No espresso/coffee,	Coffee bean hopper is not in	Adjust the hopper so that the arrow
only water is running	the correct position.	on the base of hopper is aligned
out when using		with the pre-ground coffee arrow.
pre-ground coffee.
	The pre-ground coffee	When the machine is turned on
	receptacle was filled when the	it will go through an Auto Clean
	machine was switched off.	cycle, this will discard any
		coffee grinds from the coffee
		brewing unit. Therefore ensure the
		machine is on and in the pre-
		ground position before adding
		coffee.

42