|
|
| I | X | . |
| S | e | t | - | U | p | & |
| A | d | j u | s | t | m | e | n t |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| E n g l i s h | 27 |
Q. TRAVEL WHEELS (FIGURES 30 & 31)
1.Removing Travel Wheels from Receivers (Figure 30)
a.Remove the
b.Remove the travel wheel (K) from the receiver (L).
c.Repeat for other side.
2.Inserting Travel Wheels into Receivers (Figure 30)
a.Insert the travel wheel (K) into the receiver (L).
b.Align holes at position for corresponding rear wheel size.
c.Insert the
d.Repeat for other side. Both travel wheels must be set at the same height.
3.Adjusting Travel Wheels for Frame Angle (Figures 30 & 31)
30 |
J |
L |
K |
trail |
31 |
The travel wheel bracket (A) alignment may need to be adjusted depending upon the angle of the frame’s seat rail. The travel wheel brackets have two hole patterns that offer 2 “Trail” positions (Fig. 30). To adjust the mounting configuration:
a.Remove the 2 mounting screws (B).
b.Rotate the travel wheel bracket (A) to the hole pattern that creates the smallest “Trail” dimension. Always keep the travel wheel behind the axle centerline.
c.Replace the 2 mounting screws (B), and torque to 106
d.Repeat for other side. Both travel wheels must be set at the same angle.
NOTE– When the wheelchair is configured with the travel wheel and
R. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All acces- sories should also perform smoothly. If you have any problems, follow these procedures:
a. Review assembly and adjustment sections to make sure chair was properly prepared. b. Review trouble shooting guide.
c. If your problem persists, contact your authorized supplier. If you still have a problem after contacting your authorized supplier, contact Sunrise customer service. See the introduction page for details on how to contact your authorized supplier or Sunrise customer service.
C A
B
050105 Rev. C
