SUPER MICRO Computer 1012G-MTF Installing Memory, Memory Support, Release Tab Front View

Release Tab

A+ SERVER 1012G-MTF USER'S MANUAL

5-6 Installing Memory

Installing Memory

1.Insert each memory module vertically into its slot, paying attention to the notch along the bottom of the module to prevent inserting the module incorrectly (see Figure 2-1).

2.Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/ DIMM4A, etc. Always install in groups of four and in the numerical order of the DIMM slots. See support information below.

3.Gently press down on the memory module until it snaps into place.

Note: 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules are supported. It is highly recommended that you remove the power cord from the system before installing or changing memory modules. Please refer to our web site for memory that has been tested on the H8SGL-F motherboard.

Memory Support

The H8SGL -F motherboard supports single/dual/tri/quad - channel, DDR3-1600/1333/1066 Mhz MHz registered ECC/Unbuffered ECC/non-ECC SDRAM.

Populating four adjacent slots at a time with memory modules of the same size and type will result in interleaved (128-bit) memory, which is faster than non-interleaved (64-bit) memory.

To Install: Insert module vertically and press down until it snaps into place.

Figure 5-4. DIMM Installation
Notch	Notch

Pay attention to the alignment notch at the bottom.

To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should

Release Tab

Front View

Note: Notch should align with the receptive key point on the slot.

release it from the slot.

Top View of DDR3 Slot

5-8