H8DMT/H8DMT-IBX/H8DMT-F/H8DMT-IBXF User’s Manual
Figure 2-9. Jumper Connector Pins and Setting
3 2 1 Connector 
Pins
Jumper
3 2 1
Setting
CMOS Clear
JBT1 is used to clear CMOS, which will also clear any passwords. Instead of pins, this jumper consists of contact pads to prevent accidentally clearing the contents of CMOS.
To Clear CMOS
1.First power down the system and unplug the power cord(s).
2.With the power disconnected, short the CMOS pads with a metal object such as a small screwdriver.
3.Remove the screwdriver (or shorting device).
4.Reconnect the power cord(s) and power on the system.
NOTE: Do not use the PW_ON connector to clear CMOS.
LAN Controller Enable/Disable
The JPL jumper allows you to enable or diable the serverboard’s LAN controller. The default position is on for both pins 1 and pin 2 to enable the LAN Controller. See the table below for jumper settings.
Jumper Setting | Definition |
Pins | LAN Controller Enabled (Default) |
|
|
Pins | LAN Controller Disabled |
|
|
