![](/images/new-backgrounds/1303375/303375121x1.webp)
:
Checkpoint | Code Description | |
82h | The keyboard controller interface test completed. Writing the command byte and | |
initializing the circular buffer next. | ||
| ||
83h | The command byte was written and global data initialization has completed. | |
Checking for a locked key next. | ||
| ||
84h | Locked key checking is over. Checking for a memory size mismatch with CMOS | |
RAM data next. | ||
| ||
85h | The memory size check is done. Displaying a soft error and checking for a | |
password or bypassing WINBIOS Setup next. | ||
| ||
86h | The password was checked. Performing any required programming before | |
WINBIOS Setup next. | ||
| ||
87h | The programming before WINBIOS Setup has completed. Uncompressing the | |
WINBIOS Setup code and executing the AMIBIOS Setup or WINBIOS Setup | ||
| utility next. | |
88h | Returned from WINBIOS Setup and cleared the screen. Performing any | |
necessary programming after WINBIOS Setup next. | ||
| ||
|
| |
89h | The programming after WINBIOS Setup has completed. Displaying the power on | |
screen message next. | ||
| ||
8Ch | Programming the WINBIOS Setup options next. | |
|
| |
8Dh | The WINBIOS Setup options are programmed. Resetting the hard disk controller | |
next. | ||
| ||
8Fh | The hard disk controller has been reset. Configuring the floppy drive controller | |
next. | ||
| ||
91h | The floppy drive controller has been configured. Configuring the hard disk drive | |
controller next. | ||
| ||
95h | Initializing the bus option ROMs from C800 next. See the last page of this | |
chapter for additional information. | ||
| ||
96h | Initializing before passing control to the adaptor ROM at C800. | |
97h | Initialization before the C800 adaptor ROM gains control has completed. The | |
adaptor ROM check is next. | ||
| ||
|
| |
98h | The adaptor ROM had control and has now returned control to BIOS POST. | |
Performing any required processing after the option ROM returned control. | ||
| ||
99h | Any initialization required after the option ROM test has completed. Configuring | |
the timer data area and printer base address next. | ||
| ||
|
| |
9Ah | Set the timer and printer base addresses. Setting the | |
9Bh | Returned after setting the | |
initialization before the Coprocessor test next. | ||
| ||
|
| |
9Ch | Required initialization before the Coprocessor test is over. Initializing the | |
Coprocessor next. | ||
| ||
9Dh | Coprocessor initialized. Performing any required initialization after the | |
Coprocessor test next. | ||
| ||
|
| |
9Eh | Initialization after the Coprocessor test is complete. Checking the extended | |
keyboard, keyboard ID, and Num Lock key next. Issuing the keyboard ID | ||
| command next. | |
A2h | Displaying any soft errors next. | |
|
|