SUPER MICRO Computer H8DMT user manual I/O Device Configuration Submenu, DMI Event Logging Submenu

Chapter 4: BIOS

	Table 4-8. I/O Device Configuration Submenu
Menu Item		Description
		This option specifies the base I/O port address and Interrupt Request address of
		serial port 1. The options are DISABLED, 3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3.
		Select DISABLED to prevent the serial port from accessing any system resources.
Serial Port1 Address		When this option is set to DISABLED, the serial port physically becomes
		unavailable.
		Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address and
		IRQ 4 for the interrupt address.
		This option specifies the base I/O port address and Interrupt Request address of
		serial port 2. The options are DISABLED, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3.
		Select DISABLED to prevent the serial port from accessing any system resources.
Serial Port2 Address		When this option is set to DISABLED, the serial port physically becomes
		unavailable.
		Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and
		IRQ 3 for the interrupt address.

	Table 4-9. DMI Event Logging Submenu
Menu Item	Description
View Event Log	Highlight this item and press <ENTER> to view the contents of the event log.
Mark All Events as	Highlight this item and press <ENTER> to mark all events as read.
Read
Clear Event Log	Select Yes and press <ENTER> to clear all event logs. The options are YES and
	NO to verify.

	Table 4-10. Console Redirection Submenu
Menu Item	Description
Remote Access	Allows you to ENABLE or Disable remote access. If enabled, the settings below
	will appear:
Serial Port Number	Selects the serial port to use for console redirection. Options are COM1 and
	COM2.
Serial Port Mode	Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8, N,
	1), (38400 8, N, 1), (19200 8, N, 1) and (09600 8, N, 1).
Flow Control	Selects the flow control to be used for console redirection. Options are None,
	HARDWARE and SOFTWARE.
Redirection After	Options are DISABLE (no redirection after BIOS POST), BOOT LOADER
	(redirection during POST and during boot loader) and Always (redirection
BIOS POST
	always active). Note that some OS's may not work with this set to ALWAYS.
Terminal Type	Selects the type of the target terminal. Options are ANSI, VT100 and VT-UTF8.
VT-UTF8 Combo Key	Allows you to Enable or DISABLE VT-UTF8 combination key support for ANSI/
Support	VT100 terminals.
Sredir Memory	Use this setting to set the delay in seconds to display memory information.
Display Delay	Options are No Delay, 1 SEC, 2 SECS and 4 SECS.

4-7