SUPER MICRO Computer user manual Processors, Memory, SBA-7222G-T2 Blade Specification Features

SBA-7222G-T2 Blade Module User’s Manual

1-3 Blade Module Features

Table 1-1lists the main features of the SBA-7222G-T2 blade module. See the proceeding section for components typically included in a blade system and other optional components. Specific details on the SBA-7222G-T2 blade module is found in Chapter 4: "Blade Module Features" on page 4-1.

Table 1-1. SBA-7222G-T2 Blade Specification Features
Mainboard	BHDGT (proprietary form factor)
	Blade Module Chassis Dimensions (HxWxD): 11.32” x 1.67” x 20.5”
Processors	Supports two 1944-pin G34 socket AMD Opteron 6100 series processors
	in each node for up to four processors per blade module. Please refer to
	our web site for a complete listing of supported processors.
FSB Speed	1333/1066/800 MHz speed
Chipset	AMD SR5650 & SP5100 chipset
Graphics Controller	One embedded Matrox G200eW Graphics chip with 16MB of SDRAM
BIOS	16 Mb AMI® SPI Flash EPROM BIOS
	Eight 240-pin DIMM sockets per node supporting up to 128 GB of ECC
Memory Capacity	Registered DDR3-1333/1066/800 SDRAM DIMMs or 32 GB of ECC
	Unbuffered DDR3-1333/1066/800 SDRAM DIMMs.
SATA Controller	SATA Controller SP5100 on-chip controller for four Serial ATA drives total
	(two per node).
Hard Drive Bays	Four (4) hot-swap drive bays for 2.5" SATA disk drives (two per node)

Processors

The SBA-7222G-T2 blade module supports up to two 1944-pin G34 socket AMD Opteron 6100 series processors in each node for a total of four.

Refer to the Supermicro web site for a complete listing of supported processors (http:// www.supermicro.com/products/superblade). Please note that you will need to check the detailed specifications of a particular blade module for a list of the CPUs it supports.

Details on installation of the processor into the SBA-7222G-T2 blade module are found in Chapter 3: "Setup and Installation" on page 3-1.

Memory

The SBA-7222G-T2 blade module has eight 240-pin DIMM sockets in each node that can support up to 32 GB of ECC Unbuffered DDR3-1333/1066/800 SDRAM or 128 GB of ECC Registered DDR3-1333/1066/800 SDRAM DIMMs. Both interleaved and non-interleaved memory are supported, so you may populate any number of DIMM slots.

Please refer to the Supermicro web site for a list of supported memory

(www.supermicro.com/products/superblade). The detailed specifications for a blade module will contain a link to a list of recommended memory sizes and manufacturers.

1-2