SUPER MICRO Computer SBA-7222G-T2 user manual Memory wraparound at 00 next

SBA-7222G-T2 Blade Module User’s Manual

	Table A-4. Uncompressed Initialization Error Codes
Post Code	Description
40h	Preparing the descriptor tables next.
42h	The descriptor tables are prepared. Entering protected mode for the
	memory test next.
43h	Entered protected mode. Enabling interrupts for diagnostics mode next.
44h	Interrupts enabled if the diagnostics switch is on. Initializing data to check
	memory wraparound at 0:0 next.
45h	Data initialized. Checking for memory wraparound at 0:0 and finding the
	total system memory size next.
46h	The memory wraparound test is done. Memory size calculation has been
	done. Writing patterns to test memory next.
47h	The memory pattern has been written to extended memory. Writing
	patterns to the base 640 KB memory next.
48h	Patterns written in base memory. Determining the amount of memory
	below 1 MB next.
49h	The amount of memory below 1 MB has been found and verified.
	The amount of memory above 1 MB has been found and verified.
4Bh	Checking for a soft reset and clearing the memory below 1 MB for the soft
	reset next. If this is a power on situation, going to checkpoint 4Eh next.
4Ch	The memory below 1 MB has been cleared via a soft reset. Clearing the
	memory above 1 MB next.
4Dh	The memory above 1 MB has been cleared via a soft reset. Saving the
	memory size next. Going to checkpoint 52h next.
4Eh	The memory test started, but not as the result of a soft reset. Displaying
	the first 64 KB memory size next.
4Fh	The memory size display has started. The display is updated during the
	memory test. Performing the sequential and random memory test next.
50h	The memory below 1 MB has been tested and initialized. Adjusting the
	displayed memory size for relocation and shadowing next.
51h	The memory size display was adjusted for relocation and shadowing.
52h	The memory above 1 MB has been tested and initialized. Saving the
	memory size information next.
53h	The memory size information and the CPU registers are saved. Entering
	real mode next.
54h	Shutdown was successful. The CPU is in real mode. Disabling the Gate
	A20 line, parity, and the NMI next.
57h	The A20 address line, parity, and the NMI are disabled. Adjusting the
	memory size depending on relocation and shadowing next.
58h	The memory size was adjusted for relocation and shadowing. Clearing
	the Hit <DEL> message next.

A-8