SBA-7222G-T2 Blade Module User’s Manual
Super IO Device Configuration
The menu options in the SUPER IO CONFIGURATION submenu and their descriptions are shown in Table
| Table |
|
|
Menu Option | Description |
| This option specifies the base I/O port address and Interrupt Request address of |
| serial port 1. The options are DISABLED, 3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3. |
| • Select DISABLED to prevent the serial port from accessing any system |
Serial Port1 Address | resources. When this option is set to DISABLED, the serial port physically |
| becomes unavailable. |
| • Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address |
| and IRQ 4 for the interrupt address. |
|
|
| This option specifies the base I/O port address and Interrupt Request address of |
| serial port 2. The options are DISABLED, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3. |
| Select DISABLED to prevent the serial port from accessing any system resources. |
Serial Port2 Address | When this option is set to DISABLED, the serial port physically becomes |
| unavailable. |
| Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and |
| IRQ 3 for the interrupt address. |
Serial Port 2 Attribute | This option can set COM 2 as a normal serial port or virtual COM for SOL. |
| Options are COM or SOL. |
Remote Access Configuration
The menu options in the REMOTE ACCESS CONFIGURATION submenu and their descriptions are shown in Table
| Table | |
|
|
|
Menu Option |
| Description |
Remote Access |
| Allows you to Enable or Disable remote access. If enabled, the settings below |
| will appear. | |
|
| |
Serial Port Number |
| Selects the serial port to use for console redirection. Options are COM1 and |
| COM2* | |
|
| |
Serial Port Mode |
| Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8, N, |
| 1), (38400 8, N, 1), (19200 8, N, 1) AND (09600 8, N, 1). | |
|
| |
|
|
|
Flow Control |
| Selects the flow control to be used for console redirection. Options are None, |
| HARDWARE and SOFTWARE. | |
|
| |
Redirection After |
| Options are DISABLE (no redirection after BIOS POST), BOOT LOADER |
| (redirection during POST and during boot loader) and Always (redirection | |
BIOS POST |
| |
| always active). Note that some OS's may not work with this set to Always. | |
|
| |
|
|
|
Terminal Type |
| Selects the type of the target terminal: ANSI, VT100 and |
|
|
|
