Now you are able to select from the three alti- tude modes (Fig. 4.23.) and the three personal modes (Fig. 4.24.) and the two RGBM effect, full normal or limited attenuated, modes (Fig. 4.25.) and safety stop/deepstop 1 or 2 minutes (Fig. 4.25b).
4.3.1.2.Dive Time Alarm Setting [2 d ALARM]
The instrument has one Dive Time Alarm Set- ting, which can be used for several purposes to add to your diving safety. The alarm can be set, for example, to your planned bottom time.
To enter the Dive Time Alarm Setting Mode se- lect MODE- 3 SET- 1 SET DIVE- 2 d ALARM. The Dive Time alarm can be set on or off and the time from 1 to 999 minutes.
4.3.1.3.Maximum Depth Alarm Setting [3 MAX DPTH]
You can set one depth alarm in the dive com- puter.
To enter the Maximum Depth Alarm Setting select MODE- 3 SET- 1 SET DIVE- 3 MAX DEPTH .
The depth alarm is set to 40 m [131 ft] at the factory, but you are able to adjust it according your personal preference or switch it off. The depth range can be set from 3.0 m to 100 m [9 ft to 328 ft] (Fig. 4.27.).
4.3.1.4.Nitrox/Oxygen Settings [4 NITROX]
If set to the Nitrox mode, the correct oxygen percentage of the gas in your cylinder (and additional gases) must always be entered into the computer to ensure correct nitrogen and oxygen calculations. Also, in Nitrox mode, the oxygen partial pressure limit must be set.
Fig. 4.25b. Setting Safe- tystop/Deepstop. Press scroll buttons to change safety/deep stop
OK
DIVE TIME
Fig. 4.26. Setting Dive Time Alarm. Press scroll buttons to change alarm on/off and to set dive time value.
m
MAX
OK
Fig. 4.27. Setting Maxi- mum Depth Alarm. Press scroll buttons to change alarm on/off and to set maximum depth value.
53
