Tank pressure and ascent rate indicator are also displayed during the dive (Fig. 3.28.). Remaining Air Time, temperature and current time are shown in the alternative display when the TIME button is pressed.
NOTE! If you dive with the Gauge mode, it is not possible to change between the modes within 48 hours.
3.6. AT THE SURFACE 3.6.1. Surface Interval
An ascent to any depth shallower than 1.2 m [4 ft] will cause the DIVING display to be replaced by the SURFACE display, giving the following information (Fig. 3.29.):
•maximum depth of last dive in me- ters [ft]
•present depth in meters [ft]
•
•Altitude Adjustment setting
•Personal Adjustment setting
•Diver attention symbol indicates attenuated RGBM model has been set
•Flashing Diver attention symbol indicates surface interval time should be prolonged (Table 3.3)
•STOP label for 5 min, if the Mandatory Safety Stop was violated
•Er, if the decompression ceiling was violated (= Error Mode) (Fig. 3.32, Table 3.3)
•Cylinder pressure in bars [psi] (if “on”, if “off” temperature is shown)
•dive time of last dive in minutes, shown as DIVE TIME.
| m |
| MAX |
bar | DIVE TIME |
Fig. 3.28. Diving in Gauge mode. Current dive time is 30 minutes 21 seconds.
| m |
| MAX |
NO |
|
bar | DIVE TIME |
Fig. 3.29. Surface dis- play. You have surfaced from a 18 minute dive, which maximum depth was 20.0 m [66 ft]. The present depth is 0.0 m [0 ft].Airplane symbol indicates that you should not fly and blinking Diver Attention Symbol indicates that you should prolong your surface interval time because of excess micro-bubbles.
35
