Sylvania LD320SS1, A9DF1UH owner manual  Playback,  Disc Menu,  Resume Playback, Dvd

OPERATING DVD

These operations are accessible by remote control. Some may also be accessible by controls on the main unit.

Playback

Before you begin:

Turn on the amplifier and any other equipment which is connected to this unit. Make sure the external audio receiver (not included) are set to the correct channel.

1 Press [POWER] to turn on the unit.

2 Insert a disc with label facing forward.

Disc Menu

DVD

Some discs contain disc menus which describe the contents of the disc or allow you to customize disc playback, or title menu which lists the titles available on the DVD.

To display the DVD menu, press [DISC MENU] and use [Cursor K / L / s / B] to select an item, then press [ENTER] (or [PLAY B]).

To display the top menu, press [TITLE] and use [Cursor K / L / s / B] to select an item, then press [ENTER] (or [PLAY B]).

Note:

•Menu operations may vary depending on the disc.

Refer to the manual accompanying the disc for more details.

•In case the DVD was recorded on both sides, make sure the label of the side you want to play back is facing forward.

3 The unit switches to the DVD mode when the unit was in TV mode and detects the type of disc.

e.g.) DVD

DVD

Resume Playback

Press [STOP C] during playback. Resume message will appear on the TV screen.

Press [PLAY B]. Playback will resume from the point at which playback was stopped.

Resume ON

Press 'PLAY' to play from here. To play the beginning,

press 'STOP' first and then 'PLAY'.

•Press [PLAY B] if the unit does not go to the DVD mode.

4 The unit starts playback.

•If playback does not start automatically, press [PLAY B] again.

5 Press [STOP C] to stop playback temporarily.

•If playback remains stopped for 20 minutes, the unit will turn itself off automatically when “AUTO POWER OFF“ is set to “ON“.

6 Press [A EJECT] to eject the disc.

Note:

• “ ” may appear at the top-right on the TV screen when the operation is prohibited by the disc or this unit.

•Some DVD may start playback from title 2 or 3 due to specific programs.

•During the playback of a 2-layered disc, pictures may stop for a moment. This happens while the 1st layer is being switched to the 2nd layer. This is not a malfunction.

•When you cannot remove the disc, you may try either following operations.

-Press and hold [A EJECT] on the unit for more than 5 seconds.

-Unplug the AC power cord and plug it in again, then press [A EJECT].

It will take about 10 seconds to eject the disc, while that the unit will not respond to any key commands.

36

Note:

•To cancel resume, press [STOP C] one more time in the stop mode. On some discs, [STOP C] will not work while the resume message appears. Please wait until the message disappears.

•The resume information will be kept even when the unit is turned off. However, ejecting the disc will cancel the resume feature. Playback will start at the beginning the next time you insert the disc.

Paused and Step-by-step Playback

Press [PAUSE F] during playback.

• Playback will be paused and sound will be muted.

To continue playback, press [PLAY B].

DVD

Each time you press [PAUSE F] in the pause mode, the disc goes forward one frame at a time.

To continue playback, press [PLAY B].

Note:

•Set “STILL MODE” to “FIELD” in the “OTHERS” menu if pictures in the pause mode are blurred. Refer to page 47.

EN