Monitoring Statistics 7-33
5. Click the Send Cfg to APs button to send the your AP-5131’s configuration to other AP-
5131’s. Recipient AP-5131 must be the same single or dual-radio model as the AP-5131
sending the configuration. The sending and recipient AP-5131’s must also be running the
same major firmware version (i.e., 1.1 to 1.1).
6. Click the Start Flash button to flash the LEDs of other AP-5131s detected and displayed
within the Known AP Statistics screen.
Use the Start Flash button to determine the location of the devices displayed within the
Known AP Statistics screen. When an AP-5131 is highlighted and the Start Flash button is
selected, the LEDs on the selected AP-5131 flash. When the Stop Flash button is selected,
the LEDs on the selected AP-5131 go back to normal operation.
7. Click the Logout button to securely exit the AP-5131 Symbol Access Point applet. A prompt
displays confirming the logout before the applet is closed.
CAUTION When using the Send Cfg to APs function to migrate an AP-5131’s
configuration to other AP-5131s, it is important to keep in mind mesh
network configuration parameters do not get completely sent to other
AP-5131s. The Send Cfg to APs function will not send the
“auto-select” and “preferred list” settings. Additionally, LAN1 and
LAN2 IP mode settings will only be sent if the sender’s AP mode is
DHCP or BOOTP. The WAN’s IP mode will only be sent if the sender’s IP
mode is DHCP.
!