20 Model H63Operating Procedures
Step 4
Install the draw valve. Slide the two o--rings onto the
draw valve and lubricate.
Figure 8
Lubricate the inside of the door spout, top and bottom ,
andins ert the draw valve into the freezer door from the
top. It will be necessary to rotate the draw valve to the
right when assembling the door to the freezer.
Figure 9
Step 5
Assemble the freezer door. Place the large rubber
gasket into the groove on the back side of the freezer
door. DO NOT lubricate the gasket.
Slide the white plastic front bearing onto the bearing
hub, making certain that the flanged end of the bearing
is resting against the freezer door. DO NOT lubricate
the front bearing.
Figure 10
Install the freezer door. Locate the torque rotor in the
center hole of the freezer door. Position the door on t he
four studs on the front of the freezing cy linder and
firmly push it into place. Install the four handscrews on
the studs and finger--tighten equally in a criss--cross
pattern to insure the door is snug. Do not
over--tighten.
Figure 11