23
Model H63 OperatingPro cedures
Step 9
Stand the assembled air tubes in the corner of themix
hopper and place the agitator on the agitator housing.
Figure 20
Note: If the agitator stops turning during normal
operation, remove the agitator from the agitator
housing and brush clean these parts wit h sanitizing
solution. Install the agitator back onto t he agitator
housing. Be sure your hands are sanitized w hen
performing this step.
Priming
Step 1
Place a mix pail beneath the dispensing spout, and
open the draw valve. Pour two gallons (7.6 liters) of
FRESH mix into the mix hopper and allow it to flow int o
the freezing cylinder. This will force out any remaining
sanitizing solution.
Figure 21
When full strength mix is flowing from the dispensing
spout, close the draw valve.
Figure 22
Step 2
When mix stops bubbling down into the freezing
cylinder, install the assembled air tubes in the mix inlet
hole.
The pin on the inner air tube should be turned and
positioned at the bottom of the notch in the outer air
tube. This will align the holes in the air tubes and allow
mix and air to enter the freezing cylinder.
Figure 23