Taylor 048887-M

Model H63 OperatingPro cedures

Step 6

Install the rear drip pan. Slide the drip pan into the hole

in the front panel.

Figure 12

Step 7

Install the torque arm. Position the torque arm by

slipping it up through the slot in the operating arm, and

then down into the hole in the torque rotor shaft. Check

the torque arm by moving it back and f orth to be sure

it moves freely and easily.

Step 8

Install the front drip tray and splash shield.

Figure 13

Step 9

Slide the three o--ringsinto t he grooves of the inner air

tube.

Figure 14

Slide the two o--rings into the grooves of the outer air

tube.

Figure 15

Step 10

Lay the inner air tube, outer air tube, and agitator in the

bottom of the mix hopper for sanitizing.

Figure 16

Contents

Main Page Table of Contents Table of Contents -- Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Water Connections Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warranty Disclaimer Section 3 Safety S 7 Model H63 OperatorParts Identification Section 4 Operator Parts Identification H63 8Model H63Operator Parts Identificati on H63 Door and Beater Assemblies Accessories U L B E Section 5 Important: To the Operator H63 Symbol Definitions Power Switch Liquid Crystal Display LED Indicator -- MIX LOW LED Indicator -- MIX OUT Consistency Control Product Ready Light Page Page Operator Menu Clearing Fault Tones Page Page Section 6 Operating Procedures Assembly Page Page Page Sanitizing Priming Daily Closing Procedures Daily Opening Procedures Manual Brush Cleaning S S S S Draining Product From The Freezing Cylinder Rinsing Hopper Cleaning Disassembly Brush Cleaning S S S S S Section 7 Important: Operator Checklist During Cleaning and Sanitizing Troubleshooting Bacterial Count Regular Maintenance Checks Winter Storage Section 8 Troubleshooting Guide Page Page Page Page Section 9 Parts Replacement Schedule Section 10 Parts List