Taylor 342 manual Safety, Section, To Operate Safely, Models 340, 341

Section 3 Safety

We at Taylor are concerned about the safety of the operator when he or she comes in contact with the freezer and its parts. Taylor has gone to extreme efforts to design and manufacture built-in safety features to protect both you and the service technician. As an example, warning labels have been attached to the freezer to further point out safety precautions to the operator.

IMPORTANT -- Failure to adhere to the following safety precautions may result in severe personal injury. Failure to comply with these warnings may damage the machine and its components. Component damage will result in part replacement expense and service repair expense.

To Operate Safely:

DO NOT operate the freezer without reading this operator’s manual. Failure to follow this instruction may result in equipment damage, poor freezer performance, health hazards, or personal injury.

SDO NOT operate the freezer unless it is properly grounded.

SDO NOT attempt any repairs unless the main power supply to the freezer has been disconnected.

SDO NOT operate the freezer with larger fuses than specified on the freezer data label.

Failure to follow these instructions may result in electrocution or damage to the machine. Contact your local authorized Taylor Distributor for service.

DO NOT use a water jet to clean or rinse the freezer. Failure to follow this instruction may result in serious electrical shock.

SDO NOT allow untrained personnel to operate this machine.

SDO NOT operate the freezer unless all service panels and access doors are restrained with screws.

SDO NOT remove the door, beater, scraper blades, drive shaft, or torque rotor shaft unless all control switches are in the OFF position.

SDO NOT put objects or fingers in the door spout.

Failure to follow these instructions may result in contaminated product or severe personal injury to fingers or hands from hazardous moving parts.

USE EXTREME CAUTION when removing the beater assembly. The scraper blades are very sharp and may cause injury.

These freezers must be placed on a level surface. Failure to comply may result in personal injury or equipment damage.

DO NOT obstruct air intake and discharge openings:

Models 341/342: 3” (76 mm) minimum air space on all sides.

Model 340: 6” (152 mm) minimum air space on sides and 0” at the rear. It is recommended to install a skirt to one side of the unit, and to place the back of the unit against a wall.

Failure to follow this instruction may cause poor freezer performance and damage to the machine.

These freezers are designed to operate indoors, under normal ambient temperatures of 70_--75_F (21_--24_C). The freezers have successfully performed in high ambient temperatures of 104_F (40_C) at reduced capacities.

NOISE LEVEL: Airborne noise emission does not exceed 78 dB(A) when measured at a distance of 1.0 meter from the surface of the machine and at a height of 1.6 meters from the floor.

061211

Models 340, 341, 342 3 Safety