Technicolor - Thomson 510, 510i, 530 Local Ethernet Connection Setup, SpeedTouch, Other equipment

1 SpeedTouch™ Installation

1.2.1. Local Ethernet Connection Setup

Local network For Ethernet connectivity you will need at least:

•A computer that already has an Ethernet Network Interface Card (NIC) installed.

•If required, a hub or switch and the necessary connection cables.

Ethernet cables In the SpeedTouch™ package, a full-wired straight-through RJ45/RJ45 Ethernet cable, hereafter referred to as a LAN cable, is included.

You can use LAN cables other than the one provided in the box. The following table indicates the LAN cable type required:

SpeedTouch™	Other equipment	Type of LAN cable
MDI-X	MDI-X	Crossover
	MDI	Straight-through

The SpeedTouch™530 features an auto-sensing MDI/MDI-X Ethernet port, you can use any type of full wired LAN cable to connect your equipment.

Standard wiring Use the LAN cable provided to wire your computer's Ethernet port to (one of) the procedure SpeedTouch™'s Ethernet port(s).

In case of a single Ethernet port SpeedTouch™510 or SpeedTouch™530, you will need an external hub or switch to connect multiple computers.

In case of a SpeedTouch™510 switch, you can create a local Ethernet network of up to four devices, without needing extra networking devices.

Ethernet link check The SpeedTouch™ LED indicators allow you to check your Ethernet.

See section “1.1 Getting Acquainted with the SpeedTouch™” on page 4 for more infor- mation.

10 3EC 37891 AAAA TCZZA Ed. 01