Technicolor - Thomson 510, 510i, 530 manual The SpeedTouch Upgrade Wizard

3 SpeedTouch™ System Software Upgrade

3.1 The SpeedTouch™ Upgrade Wizard

Using the Upgrade The procedure described in this section are valid only in case you run an MS Windows Wizard Operating System or Mac OS10.

Make sure that the SpeedTouch™ is connected to your PC/computer via its Ethernet port. In case of a SpeedTouch™530, please disconnect the USB interface, if used, to avoid communication errors during the system software upgrade.

During the upgrade procedure all configuration settings are backed up by the wizard and restored after upgrading the system software. Therefore, you do not need to back up the SpeedTouch™ configuration yourself.

Before you start Make sure that you have a valid SpeedTouch™ system software file available on a local disk or CD-ROM.

System software Following procedure describes how to use the SpeedTouch™ Upgrade wizard from a upgrade procedure PC running an MS Windows OS. For computers running Mac OS10 the behavior of the

wizard is identical. Proceed as follows:

Step		Action
1	Insert the SpeedTouch™ Setup CD-ROM in your computer's CD-ROM drive.
	•	MS Windows OSs
		The SpeedTouch™ Menu will start automatically:
		If the SpeedTouch™ Menu window does not appear automatically, open
		a 'Run' window via Start > Run from the Start menu and enter the
		following path: D:\Menu.exe, where D stands for the drive letter of your
		CD-ROM drive.
		To start the SpeedTouch™ Upgrade wizard, click SpeedTouch™
		Upgrade.
	•	Mac OS10
		Open the CD-ROM and click UpgradeST.pkg to install the upgrade
		program. After installation, go to the location where you installed the
		Upgrade application and click UpgradeST.

34 3EC 37891 AAAA TCZZA Ed. 01