Technicolor - Thomson DTH8060 manual Add a satellite or cable receiver, Adjusting the G-LINK Cable

2_DTH8060_en.qxd 17/08/05 12:21 Page 8

Connections and initial set up

Add a satellite or cable receiver

Your DVD recorder is designed to control either a cable or satellite receiver, this enables you to program the recording of satellite programmes simply by programming your DVD recorder.

In this case, the device must be connected to the AV2 and IR SAT/CABL connections of the DVD recorder. Connect cables (5) (not supplied) and cable (6) the G-LINK cable (supplied) as shown below.

Note: In grey: connections already carried out (connections from page 4),

In black: new connections.

TV set

5

DVD recorder

6

Satellite receiver

IR controller cell

Adjusting the G-LINK CABLE

The IR (infrared) controller cell must face the receiver cell of the satellite receiver.You can locate the receiver cell of the satellite receiver by bringing its remote control as close as possible to the front of the device and trying to change channels. Move the remote control one centimetre and try again.When the channel of the satellite receiver changes, locate the position on the front of the unit.Then install the IR controller cell as shown on the diagram below, facing the cell of the satellite receiver (1 or 2 cm away). If need be, use the adhesive supplied to stick the cell in place.

8