TechniSat HD S2X Additional settings/LNB properties, System examples, LNB Type, Test-Transponder

System examples

Example 1: 2 satellites (Twin-LNBs)		Example 2: 4 satellites (Twin-LNBs)		Example 3: 4 satellites (Quattro-LNBs)
		Astra 19,2°/	Eurobird-Astra 28,5°/	Astra 19,2°/	Eurobird-Astra 28,5°/
Astra 19,2°	Eutelsat 13°	Eutelsat 13°	Türksat 42°	Eutelsat 13°	Türksat 42°

AB

Position

2/1

Output

AB

Position

2/1

Output

A B C D

4/1

Output

A B C D

4/1

Output

	Multiswitch						Multiswitch
9/8						9/8
		Outputs						Outputs
			A	B	A		B
			Option		Option
			Output			Output

6

6.5.5 Additional settings/LNB properties

Once you have completed adjusting the switching matrix of your DVB receiver to the requirements of your receiving installation, you must still check and, where necessary, correct the other settings for your receiving unit.

>Use the left/right arrow keys to move the marker to the column Configuration.

>Now, in the line in which you wish to check or change the settings, use the up/down arrow keys to mark the field Continue.

>Confirm by pressing OK.

A sub-menu will be displayed in which you can make settings related to the LNB, and can set up a test transponder.

The following settings/adjustments can be made:

LNB Type

>Use the left/right arrow keys to enter the type of LNB you are using. The options are Single LNB, Quattro LNB, DisiCon 1 LNB, DisiCon 2 LNB, DisiCon

4 LNB, C-Band LNB, Circular LNB, SatCR LNB and a User LNB for manual entry of LNB data.

>If you have selected the SatCR LNB, you must then use the arrow keys to mark the line Setup and you must then start the setup by pressing the OK key.

A SatCR Scan will now be performed. Please take note of the further information displayed on the screen

Test-Transponder

The following points of this menu need only be entered if you wish to check a satellite signal of a specific satellite.

Transponder frequency

>In this line, use the numeric keys to enter a frequency on which digital programmes are broadcast.

24